Top Clamp Risers & Bars

Just select which Risers you want from the link below and then select the bars you want.
The Bars below are NOT "Tappered" like the "Beefy Drag Bars" are so ANY of the 1 1/4" Bars below titled "Chubby" bars there will be a Space on each Side of your STOCK Clamshell if you use them.
It will look like this:
BUT... You can get our "Clam Shell" Cover to Cover over it! HERE
Note: You will probably have to purchase longer cables and rewiring your switchousings at the shop your having these installed, as we've found from experience that selling cables without having the bike to measure can be a costly mistake.
There are too many ways for this to go wrong if you don't have the cables and wiring done measuring them at the shop where your installing it.
Most good shops have cables and wiring in stock.
This is why we don't sell any of the cables only Brake Lines for the Front.
If your installing this yourself, you had better be a good mechanic and done it before because you need to heat "Shrink" wrap the wiring before you feed it into the bars, as well as solder the wires to the switchousings. This is not a Novice Mechanical job!
Normally takes about 3 hours to do a handlebar job like this, if your not a mechanic it could take a full day of frustration!
YOU CAN FIND HYDRAULIC CLUTCH FITTINGS FROM "GOODRICH" HERE TO MAKE YOUR OWN CUSTOM SIZES.
AND SHOULD BE INSTALLED BY A MECHANIC THAT INSTALLS BRAKE AND CLUTCH LINES, ESPECIALLY THE ABS BRAKE LINES.
LET YOUR SHOP MEASURE THEM SO YOU DONT ORDER TOO SHORT OR TOO LONG!
IT CAN BE EXPENSIVE IF NOT MEASURED CORRECTLY!