Muscle Handlebars & Risers

Muscle Handlebars & Risers

In case you don't know the Muscle's Handlebars are all one piece with the Riser, they don't come apart.

To Replace your Stock Muscle Handlebars you will have to go with ANY Risers we have, this way you can put ANY handlebars on your Muscle.

But we have Custom Risers for putting your Stock Speedo and Cluster back your Muscle and you can use ANY Handlebars in it!

It's located on the "Custom Muscle Riser Page", and we just added the "PULLBACK Riser" if you want to KEEP Your Stock bars but would like them to come back 2" towards you, on that page too!.

The other Risers allows you to put your Stock Speedo into one of our Custom Airbox Covers and then you can put ANY Handlebars in it.

The other Risers below we have modified to put your Stock Clam Shell with your speedo on top instead of getting a "Guage Mounted Airbox Cover"

Once you do this then you can use ANY of the Handlebars listed on the page below but be sure you MEASURE them on your bike using our Shortcut on each page to see if the Controls will hit your Side Covers because the Drag bars may not be out far enough to keep it from happening!

Changing your Cables will be neccessary if the Bars you Select are Taller or Wider or have More Pullback than the Stock ones.

You will probably have to purchase longer cables and rewiring your switchousings at the shop your having these installed, as we've found from experience that selling cables without having the bike to measure can be a costly mistake.

There are too many ways for this to go wrong if you don't have the cables and wiring done measuring them at the shop where your installing it.

Most good shops have cables and wiring in stock.

This is why we don't sell any of the cables only Brake Lines for the Front.

If your installing this yourself, you had better be a good mechanic and done it before because you need to heat "Shrink" wrap the wiring before you feed it into the bars, as well as solder the wires to the switchousings. This is not a Novice Mechanical job!

Normally takes about 3 hours to do a handlebar job like this, if your not a mechanic it could take a full day of frustration!

YOU CAN FIND HYDRAULIC CLUTCH FITTINGS FROM "GOODRICH" HERE TO MAKE YOUR OWN CUSTOM SIZES.

AND SHOULD BE INSTALLED BY A MECHANIC THAT INSTALLS BRAKE AND CLUTCH LINES, ESPECIALLY THE ABS BRAKE LINES.

LET YOUR SHOP MEASURE THEM SO YOU DONT ORDER TOO SHORT OR TOO LONG!


IT CAN BE EXPENSIVE IF NOT MEASURED CORRECTLY!

Our Bars Require Internal Wiring on most All of them, that means that the wires to your Switch housings are hanging down from your Stock Bars Now will Go INSIDE the Bars when you Change them to ANY of OUR Custom Bars Below! Here's a quick Video Explaining the Process, as we Suggest you take them to a Mechanic that knows Wiring because it can be Twice as Expensive if you do it wrong!

VIDEO CLIP


Refine Search