Rear LED Brake/Turn Signals
Led Strips below and Most All the Led Kits are NOT "PLUG N PLAY" they have wires to solder and heat shrink wrap them for installation.
If you not Familiar with these Terms then you Probably Need someone else to Install them for you!
We suggest you cut off your Stock OEM Plugs from your wire harness, (they just unplug from the Electrical System) mark them for turns or brake and solder and heat wrap them to the wires after testing them on your battery to know which is which.
We get a lot of emails asking why they don't light up or that some leds are burnt out, but the leds are tested before they are shipped to us, and then they are tested here before we ship, so most likely you didn't wire them correctly, as the leds should last years and years.
If you want your led strips to also work as "Running" lights then you can order a "Dual Element" wiring system below for the BRAKE section, if you order a RED Strip, Clear Strip or Smoked Strip with Red Turns, and you want the ENTIRE Strip to light up as Running and Brake/Turns, then you will need the "Triple Play" Unit below to make All Three Sections act as Running Lights and dual function as Turns and Brake.
DO NOT USE THIS SYSTEM FOR AMBER TURNS!!!
You will get a Ticket as it's against the Law to have Amber Turns as "Running" lights!!
But you can use the "Dual Element" wire kit for the Red Brake Leds.